Article 2024 · 16 atıf

Investigation of hardness, tribological and adhesion properties of TiAlNiVN HEA films heat treated at different temperatures

Yilmaz, Ahmet Melik, Cicek, Hikmet, Duran, Semih, Gulten, Gokhan, Efeoglu, Ihsan

Özet

TiAlNiVN high entropy alloy (HEA) films were firstly produced in the literature using the magnetron sputtering system. These films were subjected to heat treatments at different temperatures between 750 degrees C and 900 degrees C. Strong TiN and VN crystal structures were observed in all the annealed films. The composition of each element constituting TiAlNiVN HEA films was within a concentration range of 5-35 %. The presence of TiAlNiVN HEA films was confirmed by X-ray photoelectron spectroscopy (XPS) analysis. D-850 film had the highest hardness of 25.7 GPa and exhibited the lowest wear rate at 2.45 x 10(-5) mm(3)/(N.m), attributable to its lowest surface roughness (0.22) and friction coefficient (0.44). Subsequent to the heat treatment, there was a substantial enhancement in the adhesion performance of the films, culminating in a high critical load value of 80 N. This study revealed that nitride-based TiAlNiVN HEA films could be enhanced in terms of hardness, tribological, and adhesion properties after heat treatment. Considering the adhesion performance, it is anticipated that the films we have produced will be a promising alternative to traditional nitride-based coatings in challenging and complex service conditions.

Anahtar Kelimeler

HEA Wear Adhesion Magnetron sputtering HIGH-ENTROPY ALLOYS NANOSTRUCTURED NITRIDE FILMS MECHANICAL-PROPERTIES OXIDATION RESISTANCE TI-6AL-4V ALLOY MICROSTRUCTURE COATINGS BEHAVIOR DESIGN PHASE

WoS Kategorileri

Engineering, Mechanical

Künye

Dergi: TRIBOLOGY INTERNATIONAL
Yıl: 2024
Cilt: 197
ISSN: 0301-679X
eISSN: 1879-2464
DOI: 10.1016/j.triboint.2024.109739
WoS UID: WOS:001345401800001

Yayını aç (DOI)